Legrand DS4015 Tee Fitting Instrukcja Użytkownika Pobierz pdf

DS4015 Tee Fitting

INSTALLATION INSTRUCTIONS

Installation Instruction No.: 43270 – January 2006

Wiremold / Legrand Electrical Systems conform to and should be

installed and properly grounded in compliance with requirements

of the current National Electrical Code, Canadian Electrical

Code, or codes administered by local authorities.

All electrical products may represent possible shock or fire

hazard if improperly installed or used. Wiremold electrical

products are UL listed to U.S. and Canadian safety

standards, made for interior use only, and should be installed

in conformance with current local and/or the National

Electrical Code.

Step 1. Mount DS4015 Base to wall using

minimum #8 fasteners as shown.

Step 2. Install Adjust-to-Fit

™

Couplings to mate with Raceway

Base. Align screws to Tabs as shown.

Step 3. Assemble the Internal Tunnel as shown and mount to the top or bottom Channel. Secure the Internal Tunnel

with supplied screws to the appropriate holes. Make sure End Stops match the Raceway Cover orientation.

Install Radius Control Inserts as shown.

Maximum

4" [102mm]

gap allowed.

Align with Tab

For more information, visit www.wiremold.com/ds4000.

Set Screw

Tab

Set Screw

Tab

NOTE: The DS4015 Tee Fitting can be configured two different ways depending on where the communication

cables are installed. Electrical wiring is meant to be housed inside the Internal Tunnel. Communication

cables are controlled by the Radius Control Inserts.

Snap

Radius

Insert

Radius Control

Insert with

Screw

End

Stops

Internal

Tunnel

Internal

Tunnel

End

Stops

1 2 3 4

DS4015 Tee Fitting 1

Podsumowanie treści

Strona 1 - DS4015 Tee Fitting

DS4015 Tee FittingINSTALLATION INSTRUCTIONSInstallation Instruction No.: 43270 – January 2006Wiremold / Legrand Electrical Systems conform to and sh

Strona 2

COVER INSTALLATION: Hook corners as shown and snap into place.ELECTRICAL WIRING – Top Channel.COMMUNICATION CABLING – Top Channel

Strona 3

Cover Removal with 650RTFITTING COVER REMOVAL – Fitting Cover can be removed using two methods:Cover Removal with ScrewdriverStep 1. Locate Dimple on

Strona 4

Wiremold / LegrandU.S. and International: 60 Woodlawn Street • West Hartford, CT 061101-800-621-0049 • FAX 860-232-2062 • Outside U.S. 860-233-6

Komentarze do niniejszej Instrukcji

Brak uwag

Legrand DS4015 Tee Fitting Instrukcja Użytkownika

Przeglądaj online lub pobierz Instrukcja Użytkownika dla Sprzęt komputerowy Legrand DS4015 Tee Fitting. Legrand DS4015 Tee Fitting User Manual Instrukcja obsługi

Podsumowanie treści

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Sprzęt komputerowy Legrand DS4015 Tee Fitting