Legrand RC7KTC Instrukcja Użytkownika
Przeglądaj online lub pobierz Instrukcja Użytkownika dla Sprzęt komputerowy Legrand RC7KTC. Legrand RC7KTC User Manual Instrukcja obsługi
- Strona / 6
- Spis treści
- BOOKMARKI
Oceniono. / 5. Na podstawie oceny klientów
IMPORTANT – PLEASE READ ALL INSTRUCTIONS BEFORE BEGINNING.
Products Covered: RC7KTC
CAUTION: Do Not operate tile stripper or resurfacing equipment over top of covers.
This may result in damage to the surface finish of the product.
Step 1. Remove junction box cover and disconnect wires. Step 2. Remove slide holder and receptacle.
Lift out receptacle and attached conductors.
CAUTION: De-energize circuit before removing junction box cover.
Step 3. Release tabs on communication jacks Step 4. Remove four #6-32 flange screws and detach
and lift out. Cut terminations. Existing existing flange. Remove two #8-32 screws
communication jacks and adapters will from plastic receptacle shell and discard.
not mount in RC7ATC flange.
RC7
Replacement Scrub Water
Cover Assembly Kit
INSTALLATION INSTRUCTIONS
Installation Instruction No.: 1 002 151 R1 – Updated October 2003
Walker
®
electrical systems conform to and should be properly grounded
in compliance with requirements of the current National Electrical Code
or codes administered by local authorities.
All electrical products may present a possible shock or fire hazard if
improperly installed or used. Walker electrical products may bear the
mark as UL Listed and/or Classified and should be installed in
conformance with current local and/or the National Electrical Code.
Podsumowanie treści
Strona 1 - Cover Assembly Kit
IMPORTANT – PLEASE READ ALL INSTRUCTIONS BEFORE BEGINNING. Products Covered: RC7KTC CAUTION: Do Not operate tile stripper or resurfacing equipment o
Strona 2 - Wiring Label
2Step 5. Cut existing carpet to 6 1/2" [165mm] Step 6. Install new receptacle barrier with two #8-32diameter surrounding existing hole. screws t
Strona 3
3Step 8. If circuit is connected to an isolated ground, apply IG icon on receptacle slide as shown. NOTE: The orange triangle shall only be placed on
Strona 4
4Step 11. Snap communication jacks or communication port plugs into flange. Step 12. Align gasket over receptacle and press bead into flange channel.C
Strona 5
5The RC7TC Series Poke-Thru Device is UL Listed and Classified to U.S. and Canadian safety standards to the following conditions: The RC7STC Poke-Thru
Strona 6 - CARPET CUTOUT TEMPLATE
The Wiremold Company U.S. and International: 60 Woodlawn Street • West Hartford, CT 061101-800-621-0049 • FAX 860-232-2062 • Outside U.S.: 860-2
Powiązane produkty i podręczniki dla Sprzęt komputerowy Legrand RC7KTC
(1 strony)
(8 strony)© 2020, manymanuals.pl. Wszelkie prawa zastrzeżone. | 0.060 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentarze do niniejszej Instrukcji